HI
RISE LORIDER BARS- Hi rise chrome bar. Good for above
the seat steering long base recumbents. About 13" rise, 24"
wide bar end to bar end and about 10" wide at center
section.
BARLORIDER---$19.95
EZ1
Hi Rise Bars - Replacement handlebars for the EZ1
recumbents. Approximately 7" at the center section (red
arrow) and 18" rise (blue arrow).Two sets of water bottle
bosses built in.
BAREZ1---$39.95 (steel version)
BAREZ1AL---$69.95 (Aluminum version)
Alloy
ATB Handlebar - Alloy handlebar. Silver.
25.4x22.2x580mm w/ 6 deg bend.
MTBBAR---$19.95
Alloy ATB Handlebar Hi Rise - Alloy handlebar. with about 5" of center rise. Allows for a more upright ride without changing stem.
BARMTBHI---$27.95
NITTO Moustache Handlebar - Alloy comfort handlebar with the ergonomic bend. Silver. 25.4 bar clamp diameter. Reverse the handlebar orientation and you have a time trial bar closer to you.
BARNTOMUSTCH---$74.95
NITTO Time Trial Handlebar - Alloy handlebar. Silver. 26.0 bar clamp diameter, 400mm wide.
BARNTOTTRIAL---$49.95
BAR END - One piece bar end with anatomic ski bend. Alloy. Silver
BAREND----$14.95
UNO Bar End - Shorter bar ends for smaller hands or folding bikes. Bar end stubs approximately 2 1/2 inches long. Alloy.
BARENDSHORT----$19.95
Cruiser
Bar - Handlebar used by cruiser bikes. By cutting a
few inches off the ends, they make for a comfortable above
the seat steering bar for short wheel base recumbents. The
bend provides for a more natural hand position compared to a
regular straight MTB bar. Can also be used as an under the
seat steerer bar.
BARRETCRUIS---$15.95
Now Available in a LIGHTER ALLOY version
BARRETCRUAL---$26.95
CANE
CREEK Ergo Controls Bar End - Ergonomically designed rubber bar ends for more comfort and control. Attaches to most MTB handlebars. Allows hand to be in a more natural position. Tacky and grippy rubber compound.
BARENDCANE----$49.95
SAKAE
ROAD HANDLEBAR - Modolo type with anatomic bend.
410mm wide. 25.4 stem clamp dia. Tube indent for cable
housing run.
RDBAR---$24.95
Road Tape - Soft peeling cushion
paded road bar tape. White
BARTAPE----$4.95
SINGLETRACK SOLUTIONS Bar End - A more cost effective bar end than the cane Creek above. Designed with the same principle allowing the hand to stay in a more natural position. Can also be used on MTB riser bars by pointing the long end towards the rider. Comes in clear or black depending on availability. A harder solid plastic grip feel.
BARENDSING----$22.95
Handlebar Shims 22.2mm to 25.4 - Some handlebars have a center bar clamp diameter of 22.2mm. Shims allow you to use stems with clamp diameter of 25.4mm
BARSHIM----$4.95
Origin8 Road Bend Bar Ends - Clamps to your mountain bike bar to give you the road bar dropped feel at the ends.
BARENDRD----$24.95
ATB Handlebar Grips - Black Kraton rubber or foam grips. Pair
BARGRIP----$5.95 (rubber)
BARGRIPFOAM---$4.95 (foam)